Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Turn the fuel cock lever
to the ON position (See
Fig.4). Set the choke le-
ver to the ON position
(see Fig.5).
Turn the engine ON/OFF
switch to the ON posi-
tion (See Fig.6).
Hold down the genera-
tor firmly with one hand
on the carrying handle.
With the other hand
grip the recoil starter
cord handle and pull
slowly until resistance is
felt indicating that the
recoil starter is engaged.
When resistance is felt
pull the cord sharply
(See Fig.7).
Continue this procedure
until the engine starts.
When the engine has
been successfully started
and is running smoothly
return the choke lever
to the OFF position (See
Fig.8).
STOPPING THE GENER-
ATOR ENGINE
• Before stopping the
engine, switch off all the
electrical loads and turn
the generator ON/OFF
switch to the OFF posi-
tion (See Fig.9).
Fig. 9
• Before stopping the engine make sure that
all the electrical loads are disconnected from
the generator AC outlet socket.
When the generator engine has stopped and
before storage, turn the fuel cock lever to the
OFF position as shown in Fig. 10
CONNECTING THE ELECTRICAL LOAD
WARNING: Before connecting any electri-
cal load to the generator ensure that the load
does not exceed the maximum load as stated
on the rating plate.
Ensure that the mains supply lead is long
enough to reach the generator without any
Fig. 5
strain.
When
the
engine has been success-
fully started and is run-
ning smoothly connect
the electrical load into
the generator AC output
socket (See Fig.11).
OVER LOAD PROTECTION
Fig. 6
The generator is fitted
with an overload protec-
tion device located on
the control panel (Fig.12).
In the event that the
load exceeds that stated
on the rating plate, the
overload protection will
operate and disconnect
Fig. 7
the load.
If the overload protection device is tripped.
Check the electrical load and if necessary re-
Fig. 8
duce the load. The overload protection device
can be re-set by pressing in the re-set button.
DC BATTERY CHARGING FUNCTION
NOTE: This function is
applicable to 12 V bat-
tery charging only.
Disconnect
from the battery. Loosen
Fig. 10
the vents on the battery.
Make sure the battery
fluid level is correct.
Attach the 12 V charging leads to the battery
observing correct polarity (Red = + Positive)
(black = - Negative).
Plug the 12 V charger lead into the socket on
the generator (Fig. 13).
NOTE: With and hydrometer check constantly
the battery liquid density. Do NOT overload.
E N G L I S H •
generator
the
leads
Fig. 13
U se r 's m a nu a l
Fig. 11
Fig. 12
9
Hide quick links:
Publicidad
Tabla de contenido
