Beta 960KPC Manual De Uso E Instrucciones página 9

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
LUBRICATION
For optimal use, connect the tool to a filter-lubricator unit provided with an air-oil microfog mixer (items 1919F...), set at two drops
per minute, pouring special oil ISO 32 (item 1919L) in. The above-mentioned accessories will translate into a highperforming
tool and wear-resistant mechanical parts. If the line is not supplied with any lubricator, pour oil ISO 32 or SAE #10 into the tool at
least once a day. Check on a monthly basis whether the clutch or the hammer device is properly lubricated. Use – if need be – SAE #30
for the clutches and bearing grease on the hammer devices. Do not use kerosene or diesel oil.
MAINTENANCE
If the tool should not start back after it has not been used for quite long, disconnect it and turn the square drive by hand, thus
preventing adhesion. Disassemble and inspect the power unit and tool assembling every 3 months if the wrench is used every
day, replacing any worn parts.
We recommend using the enclosed exploded view as a manual to disassemble and assemble the tool as well as to identify any
spare parts. Keep the tool away from dust, humidity and intense cold.
WARRANTY
This tool is manufactured and tested with the greatest care, in accordance with current safety regulations, and is covered by a
12-month warranty. We will repair any breakdowns caused by material or manufacturing defects by fixing the defective pieces or
replacing them at our discretion. Should assistance be asked for during the warranty period, the expiry date of this warranty
will remain unchanged. This warranty will not cover any defects due to wear, misuse, or breakdowns caused by blows and/or falls.
In addition, this warranty will no longer be valid if any changes are made, or if the tool is tampered with or sent to the customer
service in pieces. This warranty explicitly excludes any damage to people and/or things, whether direct or consequential.
DECLARATION OF CONFORMITY TO THE "MACHINE" DIRECTIVE
hereby certify, assuming full responsability, that the product 1/4" REVERSIBLE IMPACT WRENCH item 960 1/4
complies with the following standards, according to the requirements set by the "Machine Directive": 2006/42/CE
SPECIFICATIONS
SQUARE DRIVE
FREE SPEED
MAXIMUM TORQUE
AIR INLET
WORKING PRESSURE
MAXIMUM WORKING PRESSURE
MINIMUM INTERNAL HOSE SIZE
MAXIMUM AIR CONSUMPTION
WEIGHT
OVERALL LENGTH
DEVICE
we
BETA UTENSILI SPA
VIA A. VOLTA, 18
20845 SOVICO (MB) ITALY
Place and date of issue
SOVICO (MB) ITALY
January 2014
Name and title of the person in charge
ROBERTO CICERI
(President)
1/4"
11000 RPM
40 Nm
1/4" taper GAS
6,0 Bars
6,2 Bars
8 mm
150 l/min
0,8 Kg
135 mm
Rocking dog
EN I

9