Publicidad
Idiomas disponibles
Idiomas disponibles
AUTO SAFETY SHUT OFF
The heater has a built-in safety device, which will switch the heater
OFF in case of accidental overheating. To reset the heater, follow the
steps below:
• Turn the control setting to the 'O' position.
• Unplug the heater and wait 5-10 minutes for the appliance to cool
down.
• After the appliance has cooled, plug it in and operate it normally.
• Turn the switch into desired position (Fan, Low or High).
• Turn the thermostat switch to the desired temperature position.
• When you feel the room has reached a comfortable temperature,
turn the thermostat switch anti-clockwise slowly to the minimal
direction until the appliance switches off.
• The thermostat switch will keep the room temperature at the
desired temperature automatically.
• You can also turn the thermostat switch anti-clockwise to the
minimum position or turn the thermostat switch clockwise to the
maximum position to make the temperature lower or higher.
ANTI-TILT SWITCH PROTECTOR
• This heater is equipped with a safety tip-over switch which
automatically shuts off the heater element if the heater is not in the
upright position, the heater will resume back to normal when the
heater is returned to the upright position.
10
2.3. Maintenance
• Make sure you switch off the power supply and pull out the plug
before cleaning the appliance.
• Wait for the heater to cool down sufficiently.
• Clean the body of the heater with a damp cloth. Do not allow water
into the appliance.
• DO NOT use soap or chemicals which may damage the housing of
the heater.
• Allow sufficient drying time before operating again.
• Clean the air inlets and outlets regularly with a vacuum cleaner (if
used regularly, clean at least twice a year).
• When the appliance is not in use, we recommend re-packing it in its
original packaging and storing it in a cool, dry place.
Ceramic Fan Heater | Calefactor Cerámico | Termoventilador Cerâmico
EN
11
Publicidad
