Publicidad
Idiomas disponibles
Idiomas disponibles
8
At each fixture location attach the QuickLink Connector (C) to the low voltage cable.
i. Separate the connector
by rotating the bottom
piece counterclockwise.
9
Push the QuickLink Connector and Bluetooth Module (B) thru the ceiling opening and mount the Bluetooth Module according to local
code if required*.
Do not place Bluetooth Module or Remote Driver Box on top of the downlight.
*NOTE: If required by local code;
A. Attach Remote Driver box to structure so that it is at least 1/4" (6 mm) from the Fixture.
B. Attach Bluetooth Module to structure so that it is at least 1/4" (6 mm) from the Fixture and the Remote Driver Box.
10
Rotate both spring clips upward and
insert them through the hole in the
ceiling.
Risk of pinching -
Do not place hands under spring
during removal of the LED module.
For factory reset steps visit: support.BringHaloHome.com/SmartLight
INSTALLATION
ii. Slide the edge of the cable
into the slot of the connector's
top. (It does not matter which
edge.)
11
Continue to press the fixture through
the cutout in the ceiling until the
perimeter flange of the fixture is flush
against the ceiling. The springs will
rotate back into position and hold the
fixture tight. Repeat steps 8-11 for
each downlight.
REMOVAL
1
Simply pull down firmly on the fixture until spring clips begin to release from the
ceiling.
2
Reach through the ceiling to hold springs up and away from the ceiling as you
continue to pull the fixture from its opening.
3
Disconnect wiring.
FACTORY RESET
iii. Allowing the fixture to hang
freely, align the metal pin on
the bottom piece (attached to
the light) with the metal insert
in the top.
12
iv. Push together and rotate the
bottom piece clockwise onto
the top, until secure.
Using your smart phone/tablet,
follow the online Quick Start Guide
to pair your fixtures to your HALO
Home account.
support.BringHaloHome.com/
SmartLight
Publicidad
