MO-EL MO-LIGHT 310A Uso Y Mantenimiento página 9

Place the electric insect killer preferably at a height of about 2
metres and in the darkest point of the room, far from windows. The
reason for this is that the product has to eliminate insects in the
interior space and avoid attracting those outside. The wall should not
present obstructions to removal of the adhesive paper and cleaning
operations. Make sure that the wall where you plan to install the
product is solid and that there are no electrical wires or water pipes
behind the wall.
310A-310L
1. Unscrew the safety screw (A) and open the front body (fig. 1-2).
2. Using a drill with a 5 mm bit, make 2 holes in the wall and insert
the anchors (B)(fig. 3) (not supplied.)
3. Fix the product to the wall, introducing the 2 screws (C) in the
holes (fig. 3).
310A
4. Screw the lamp into the socket (D) (fig. 4).
310A-310L
5. Put the front body back in place and tighten the safety screw (A).
6. Insert the adhesive paper (E): remove the protective film and
allow the paper to slide along the guide (F) (fig. 5).
CLEANING AND CARE
Before cleaning or doing any maintenance on the product,
make sure that the contacts of the bipolar circuit breaker are
open or that the product is unplugged.
A general cleaning of the product is recommended every time the
adhesive paper is replaced. If food is produced in the environment,
use an appropriate non-volatile and non-contaminating cleaner. Carry
out maintenance operations only after cutting off the power supply
to the product.
310A: For better operation of the product, we recommend changing
the lamp once a year.
The adhesive paper must be changed at least once a month, more
frequently if the space is full of insects or particularly dirty. If the
adhesive paper sticks to the lamp, clean the lamp with a soft cloth
9