Napier Sportz 82000 Instrucciones página 3

Insert one end of the steel pole into the
4
corner joint. On the opposite end of the
pole, insert the pin into the grommet
hole located in the corner of the tent.
Repeat for the other
3 steel poles.
BEFORE
YOU BEGIN
For set up video,
scan QR code or visit
www.napieroutdoors.com
Outside of the tent, secure the tent to your vehicle:
9
A. Hook the bottom outside straps to any part of the wheel well and tighten (1 per side).
If applicable, ensure the exhaust pipe is outside of the sleeve. Allow the engine
and vehicle's exhaust to fully cool before installing or using the tent.
B. Tighten the bumper straps on either side of the vehicle sleeve.
Attach the pole clips.
5
From inside the tent,
6
unzip the door and mesh
that faces the vehicle
cargo area. Roll up the
mesh and door and secure
with T-straps.
Open the back hatch of
7
your vehicle.
Move the tent towards the
8
cargo area of your vehicle.
Slip the sleeve under the
bumper and over the
hatch and roof.
A. WITH A ROOF RACK
10
Remove the long strap (attached to the vehicle
sleeve) from the female clip. Attach the 2 short
straps around the roof rack and tighten. Repeat
on the opposite side.