Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT PARAMETERS
MODEL
POWER Nº LED LUMENS
LEDRP60
60W
LEDRP90
95W
INSTALLATION
Please confirm whether the products are complete before use:
1. Cross-mount – lamp body *1, adapter *1, power cord *1, acrylic support *2, screw
*4, nut *4, specification *1, quality assurance card *1.
2. Hoisting – lamp body *1, adapter *1, power cord *1, aluminum alloy support *2 sets,
installation code *2, manual *1, quality assurance card *1.
First, connect the power cord, power adapter, and lamp body power cable in turn, plug
in the power supply, test the lamp, and lift the lamp after it is normally lit. In case of any
abnormality, please contact the seller on time.
Hoisting – install the bracket, adjust the appropriate width, then install the lifting code,
put it into the track and tighten it. Finally, putt he light fixture on the bracket and tighten
the machine screw above the lifting code.
TIMING & DIMMING FUNCTION DESCRIPTION
1. Switch setting:
Put the switch button to turn on/off the light, if pull off the power the light will need to be
reset the timer & dimming, and the brightness is 100%.
2. Four-speed dimming setting: Press the button to select the corresponding brightness
position, the brightness is 25% - 50% - 75% - 100%.
3. Timer setting: It´s use cycle timer, select the time 6H/8H/10H/12H which is needed,
it will be turn on/off automatically at the same setting time in the next day. (For example:
turn on the light on 8.00am and set 12hrs, it will be turn off on 8:00pm, and it will be
repeat every day, except the power off).
Note: due to the component accuracy error of 3%, the lamp switching time may have a
deviation of several minutes, which is a normal phenomenon.
PRODUCT WARRANTY CARD
1. Provide two-years free warranty and lifelong maintenance service for the products
sold. That is, within 2 years, if the product has quality problems, free replacement
or maintenance. After the warranty, the maintenance, replacement will be charged a
certain cost.
2. Within one week after the sale, if the product is seriously affected by the quality
problem, the product can be returned, but the appearance of the product must be free
from any damage and the package must be complete. We promise to return the goods
as soon as possible upon receipt.
3. Provide corresponding technical and operational support to the products sold.
4. The following product problems not caused by our company are no within the scope of
free maintenance:
1. Failure to operate according to the instruction, voltage mismatch, lack of necessary
maintenance, etc.
2. Maintenance or modification not authorized by the company.
3. Falling into water, being affected by damp, and failing to provide the proper working
environment.
4. Product damage caused by users´ secondary transportation.
5. Faults not caused by our products.
6. Force majeure such as natural disasters (lightning strike, earthquake, tsunami, etc.)
and accidents.
ASSEMBLY
MEASUREMENTS
66
2800
570x160x100mm De 60 a 90cm
99
4400
870x160x100mm De 90 a 120cm
Timing selection
Light switch
Dimming
button
AQUARIUS
OUT
MEASURE
PUT
DC36V
Timing,
brightness
indicator
ENGLISH
VOLTAGE
AC100-240V
50Hz
Publicidad
