Glacier bay HD67798W-1108D2 Guía De Uso Y Mantenimiento página 8

Installation (continued)
7
Installing the batteries
NOTE: This step is for battery installation (optional). If the
battery will not be used, install as described in step 9.
□
To open the battery housing, squeeze the tabs (1) on the cover (2), then remove the cover (2).
□
Install the four AA batteries (J) included by matching the positive (+) and Negative (-) ends on the battery (J)
to the (+) and (-) markings in the battery pack (I). The negative ends of the battery (J) should always
connect to the spring end of the battery slots in the battery pack (I).
□
Reinstall the battery pack cover (2) by pushing up and snapping into place.
NOTE: When the sensor flashes 10 times continuously
and slowly, the batteries have lost their charge. Replace
the batteries (J).
2
1
-
3
+
-
+
-
+
-
J
I
+
2
8
I
-
+
-
+
+
-