Thompson MIC200IBT Instrucciones De Funcionamiento página 24

Wireless Charger Function
Simply place your wireless charging device on the wireless charger area indicated on the top surface
and charging will begin on contact.
Output power is 9V
USB Charging
The USB port is designed for charging external devices, such as smart phones.
Output power is 5V
AUX Input Jack
1. Press the POWER button to turn on the unit.
2. Press the SOURCE button repeatedly to select the Aux-In mode. 'Aux-In' will appear on the LCD
display.
3. Connect the AUX connect wire from the line out jack of your personal player (e.g. portable MP3
player) to the AUX input jack.
4. Start playback from your personal player.
Phone Jack
1. Rotate the Volume to set a low volume
2. Insert the headphones into the phone jack.
Note the following information: Only use the power supplies listed below.
Specification:
Power:
Remote control power source:
Frequency ranges:
Max.consumption:
Speaker impedance:
Total music output:
USB charge port output
Wireless induction
Remark: The maximum connection distance is around 10 meters. Please place your Bluetooth speaker
as close as possible to this device to avoid the connection being disturbed.
1.1A
1A
AC230V~ 50Hz 0.3A
3 Volt Lithium CR2025 battery (included)
FM: 88.8 – 108MHz
DAB/DAB+: 174 - 239MHz
Bluetooth: 2402-2480MHz
25W
4 ohms
5W X 2
5V 1A
9V 1.1A
- EN 10 -