Publicidad
Idiomas disponibles
Idiomas disponibles
•
A stud MUST be located and used for at least one side of the diaper changing station.
•
The diaper changing station is no stronger than the anchors or walls to which they are attached and, therefore, MUST be
secured in order to support the weight they are intended to support. Contact an architect or building contractor
if any questions.
1. Locate wood stud where one side of changing station will be mounted to the wall.
Measure up 42" (107 cm) from the
for the top attachment hole.
NOTE: Mark on wall MUST be in center of wood stud.
3. Align hole in top corner of changing station with mark on wall and hold in place.
4. Using a level, mark the remaining three (3) holes. After marking holes,
set changing station down on ground.
5. Use a power drill and appropriate bit to drill four (4) holes in the wall.
OPTION 1: For mounting into studs:
:
- Using a 1/8" drill bit, drill the pilot holes. if the finished surface has tile or
masonry, use 1/4" masonry bit through the overlying material, then
switch to a 1/8" bit.
OPTION 2: For mounting into hollow wall:
- Using a 1/2" drill bit, drill the pilot holes.
- Install anchors into the 1/2" holes following the "using Toggle Anchors"
guide below.
6. - Align the holes in the changing station with the drilled holes. Attach the stud side(s) of
the unit using the flat washers, finishing washers, and wood screws into the wood studs
(Figure a.) and the hollow wall side(s) using the flat washers, finishing washers and
machine screws into the anchors (Figure b).
- Ensure all screws are tight and install the 6 provided white caps.
Note: Steel stud or solid wall construction require additional hardware. Please contact a
professional contractor for assistance in determining suitable hardware
All 4 of these locations MUST be used for safe installation. The lower holes provide reinforced
installation through the metal brackets.
Using Toggle Anchors (Fig. c.) :
1. Insert metal end of toggle anchor into 1/2" hole.
2. Use Toggle handles to flip the metal toggle upright against the inside wall surface.
3. Slide zip strip down snugly against wall.
4. Snap off break-away pieces of toggle anchor.
1
WARNING
and mark the wall. This locates the position
WARNING
2
Fig. c
2
Flat
Washer
Finishing
Washer
Wood
Screw
Changing
Changing
Station
3
Wood Stud
Fig. a
Station
Toggle
Anchor
Wood Stud
Flat
Washer
Machine
Screw
Fig. b
4
Publicidad
