Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
CAUTION
• Before connecting the garden hose into the equipment, let the water run inside the hose to expel any
foreign matter inside. If the water supply comes from a well, the hose length shall be 30 ft maximum, and an additional
filter shall be used to prevent sand entering into the system.
• Using a reinforced hose (not included) with standard connection and with 0.6"outer diameter; 1/2" inner diameter and
33 ft maximum length is recommended.
• Unroll both, the garden hose and high pressure hose completely to prevent pressure fluctuation.
• The following instructions are for replacing the high-pressure hose if damaged:
• Connect the high-pressure hose (A) to the high-pressu-
re outlet (B). To connect, pull the safety to release the
lock (C). Insert the hose connection in the outlet orifice all
the way and push the safety to close the lock securing the
connection (D).
A
C
D
• Connect the other end of the high-pressure hose in the
high-pressure gun orifice (H). Press the key (H
Insert the connector into the gun orifice all the way
and release the key to fasten the connector in
place.
• Firmly thread the lance (I) in the
high-pressure gun tip.
I
B
B
1
• Verify the washer
connection to the spool
(B
) is properly fastened.
1
The blocking system is
equal to the high-pressure
outlet connection.
).
1
WARNING
use only original replacement parts from the
manufacturer or approved by the manufacturer.
WARNING
Is important the connector has the filter
(F) to prevent sand, silt, stones or any impurity damaging
the washer. Using the connector with no filter makes the
warranty void.
F
H
1
To ensure the safety of the appliance,
E
G
H
7
ENGLISH
Publicidad
