Oursson MM2009 Manual De Instrucciones página 17

6. and documents that confirm the fact and date of
the contract of retail purchase. In the absence of
such documents, warranty period is calculated
from the date of manufacture of goods. It should
be taken into account:
• Setup and Installation (assembly, the connection,
etc.) of the product described in the documenta-
tion attached to it, does not enter the scope of
warranty and can be performed by the user as
well as the specialists of most authorized service
centers on a paid basis.
• Work upon maintenance of products (cleaning
and lubricating the moving parts, replacement of
consumables and supplies, etc.) are made on a
paid basis.
7. The manufacturer is not responsible for any dam-
age directly or indirectlycaused by their products
to people, pets, property, if it occurred as a result
ofnon-observance of the rules and conditions of
use, storage, transportation or installation of the
product, intentional or negligent actions of con-
sumer or third parties.
8. Under no circumstances, the manufacturer is not
responsible for any special, incidental, indirect or
consequential loss or damage, including but not
limited to: lost profits, damages caused by inter-
ruptions in the commercial, industrial or other
activities, arising from the use of or inability to use
the product.
9. Due to continuous product improvement, design
elements and some technical specifications are
subject to change without prior notice from the
manufacturer.
Using the product when after the terms of use
(lifetime):
1. Lifetime set by manufacturer for this product ap-
plies only when the product is used exclusively for
personal, family or household needs, as well as the
consumer observes the correct operation, storage
and transportation of products. Under thecondition
of careful handling of the product and compliance
with the rules of operation the actual life may ex-
ceed the lifetime set by manufacturer.
2. At the end of the product lifetime, you should
contact an authorized service center for to con-
duct a preventive maintenance of the product and
determine the suitabilityfor further use. Work on
conducting a preventive maintenance of the prod-
ucts is also made in service centers on paid basis.
3. The manufacturer does not recommend the use
of this product after the end of its lifetime with-
out its preventive maintenance by the authorized
service center, since inthis case, the product can
be dangerous to the life, health or property of the
consumer.
Product Recycling and Disposal
This appliance has been identified in accordance with
the European directive 2002/96/EG on Waste Electrical
and Electronic Equipment – WEEE.
After the expiration of the lifetime, the product cannot
be disposed with another household waste. Instead, it
shall be deposited in the appropriate recycling collection
point for electrical and electronic equipment for proper
treatment and disposal in accordance with federal or
local law. By disposing correctly this product, you will
help to conserve natural resources and preventing the
product from damaging the environment and
human health. For more information on the
collection point and recycling of this product,
please contact your local municipal authorities
or the enterprise for household waste disposal.
Date of manufacture
Each product has a unique serial number in the form
of alphanumeric row and is duplicated with a barcode
that contains the following information: name of the
product group, date of manufacture, serial number of
the product.
Serial number is located on the rear of the product,
on the package and the warranty card.
The first two letters-correspondence to the
product group (microwaves – MM/MD).
The first two digits – year of manufacture.
The second two digits – month of manufacture.
The last two digits – serial number of product.
To avoid misunderstandings, we highly
recommend you to read carefully the in-
struction manual and the warranty obliga-
tions. Check the correctness of the war-
ranty card. Warranty card is valid only if the
following are correctly and clearly stated:
model, serial number, date of purchase,
clear stamps, buyer's signature. The se-
rial number and the model of the device
must be the same as in the warranty card.
If these conditions are not fulfilled or the
data specified in the warranty card was
changed, the warranty card is invalid.
17