Ryobi PBLRS01 Manual Del Operador página 7

 Never use gasoline since normal sparking of motor could
ignite fumes.
 Clamp the workpiece firmly and cut close to the clamping
point to eliminate any vibration of the work. When cutting
conduit pipe or angle iron, clamp the workpiece in a vise
if possible and cut close to the vise. To cut thin sheet
WARNING:
When servicing use only identical replacement parts. Use
of any other parts can create a hazard or cause product
damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
To avoid serious personal injury, always remove the bat-
tery pack from the tool when cleaning or performing any
maintenance.
LED LIGHT FUNCTIONS
TOOL STATUS
Normal
Low Battery
Excessive Force
Over Temperature
*More than 9 flashes will result in the need to remove the battery and reinsert a few minutes later.
NOTE: ILLUSTRATIONS START ON PAGE 8 AFTER
OPERATION
MAINTENANCE
TROUBLESHOOTING
LED LIGHT SCENARIO
Solid Light (No Flashes)
FRENCH AND SPANISH LANGUAGE SECTIONS.
material, "sandwich" the material between hardboard or
plywood and clamp the layers to eliminate vibration and
material tearing.
 Always hold the saw with both hands to keep firm
pressure on the shoe assembly to hold it securely against
the workpiece.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which can result in serious personal injury.
3 Flashes
6 Flashes
9 Flashes
7 – English
ACTION REQUIRED
No Action Needed
Replace Battery
Wait 5 Seconds
Let Tool Cool Off