Perel AC028 Manual Del Usuario página 6

4. Description
Refer to the illustrations on page 2 of this manual.
1 power plug
2 mains cable
5. Operation
5.1 Before Use
5.2 Connection
1. Connect the charger to the battery.
2. Connect the power cable of the battery charger to the mains.
The LED will light.
3. Stop the charging at any time by disconnecting the charger from
the mains.
Charging will not start if the clamps are in reverse connection.
5.3 Stage Charging
Stage 1 – Bulk/rapid start charge (20-70 % charge)
The charger delivers maximum charging amperage to "wake up" the
connected battery. When it reaches a maximum safe predetermined
voltage, the digital sensors automatically move into stage 2 of the
charging process. The charging LED lights.
V. 01 – 21/08/2017
WARNING
 Before connecting the battery
charger, read the operating
instructions carefully.
 In addition, observe the vehicle
manufacturer's instructions for a
permanently connected battery.
Turn off the ignition.
 Clean the battery terminals.
Ensure that your eyes do not
come in contact with the dirt in
the process.
 Ensure sufficient ventilation.
AC028
3
4
6
charging cable
clamp
©Velleman nv