Publicidad
Idiomas disponibles
Idiomas disponibles
20
Home
Technical background
The philosophy behind NeuLog's plug and play
technology is based on each sensor's ability to store its
own data due to an internal flash memory chip and
micro-controller in each plastic NeuLog body. This
technology allows the sensor to collect and then store
the digital data in the correct scientific units (for
o
o
example:
C,
F, Lux, %, ppm).
The sensor is pre-calibrated at the factory. The built-in
software in the logger can be upgraded for free at any
time using the provided firmware update.
The NeuLog current sensor houses a shunt resistor and
an amplifier. The circuit's current passes through the
shunt resistor and its electric potential is measured using
a very fast, high input impedance differential operational
amplifier with protected inputs. Using ohm's law (I = V/R)
the current is calculated from the known resistance and
voltage values.
The shunt resistor is very high power (to protect it in high
current) and very small resistance (in order not to affect
the circuit conditions). The protection is up to 5A.
V2018.01
English
Publicidad
