Power Dynamics PD632 Serie Manual De Instrucciones página 4

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
OVERVIEW
1. Power ON/OFF
2. IR Sensor
3. Display
4. Up/Down buttons
5. Set button (Functions: frequency, auto-search, lock, IR)
6. Volume controller
7. BNC antenna connector
8. Mix output 6.3mm Jack connector
9. Balanced XLR output microphone channel B
10. Balanced XLR output microphone channel A
11. DC power Jack for external power supply (12V DC 1000mA)
DISPLAY
1. RF Signal Strength
Number of bars corresponds to RF signal strength.
2. AF Audiosignal Strength
Number of bars corresponds to AF audiosignal strength.
3. Radio frequency
4. Transmission channel
5. IR Transmission
Active muting
6.
4