Publicidad
Idiomas disponibles
Idiomas disponibles
f)
Do not restart the cutting operation in the workpiece. Let the wheel reach
full speed and carefully re-enter the cut. The wheel may bind, walk up
or kickback if the power tool is restarted in the workpiece.
g)
Support panels or any oversized workpiece to minimize the risk of
wheel pinching and kickback. Large workpieces tend to sag under their
own weight. Supports must be placed under the workpiece near the line
of cut and near the edge of the workpiece on both sides of the wheel.
h)
Use extra caution when making a "pocket cut" into existing walls or
other blind areas. The protruding wheel may cut gas or water pipes,
electrical wiring or objects that can cause kickback.
Additional safety instructions for wire brushing operations
Safety warnings specific for wire brushing operations:
a)
Be aware that wire bristles are thrown by the brush even during ordinary
operation. Do not overstress the wires by applying excessive load to
the brush. The wire bristles can easily penetrate light clothing and / or
skin.
b)
Allow brushes to run at operating speed for at least one minute before
using them. During this time no one is to stand in front or in line with the
brush. Loose bristles or wires will be discharged during the run-in time.
c)
Direct the discharge of the spinning wire brush away from you. Small
particles and tiny wire fragments may be discharged at high velocity
during the use of these brushes and may become imbedded in your
skin.
TECHNICAL SPECIFICATIONS
Mains voltage: 120V~60Hz(US)/(CA)
Power input: 200W(US)/(CA)
No load speed: 10,000 - 40,000 rpm
Collet: max ø3.2mm
Protection class: II / 回
WARNING
Always wear eye protection when using this tool. Failure to do that
could result in objects being thrown into your eyes and cause possible
serious injury.
WARNING
Do not use any attachments or accessories not recommended by the
manufacturer of this product. The use of attachments or accessories
not recommended can result in serious personal injury.
Applications
You may use this product for the purposes listed below:
●
Cutting
●
Sanding
- 06 -
Publicidad
