Publicidad
Idiomas disponibles
Idiomas disponibles
Chapter 4
Trou bleshooti ng
Most problems you encounter wit � your TV can b �
corrected by consulting the followmg troubleshootmg 11st.
No picture, no sound .
1. Check if the fuse or cIrcuIt breaker Is workmg.
2. Plug another electrical device into the outlet to make
sure it is working or turned on.
3. Power plug is in a bad contact with the outlet.
4. Check the signal source.
No color
1. Change the calor system.
2. Adjust the saturation.
3. Try another channel. Black-white program may be
received.
Remote control does not work
1. Change the batteries.
2. Batteries are not installed correctly.
3. Main power is not connected.
No picture, normal sound
1. Adjust the brightness and contrast.
2. Broadcasting failure may happen.
Normal picture, no sound
1. Press the Vol+ button to increase volume.
2. Volume is set to mute, press the mute button to
restore sound.
3. Change the sound system.
4. Broadcasting failure may happen.
Unorderly ripples on the picture
lt is usually caused by local interference, such as cars,
daylight lamps and hair driers. Adjust the antenna to
minimize the interference.
Snowy dots and interference
lf the antenna is located in the fringe area of a telev1s1on
signal where the signal is weak, the picture may be
marred by dots. When the signal is extremely weak,
it may be necessary to install a special antenna to
improve the reception.
1. Adjust the position and orientation of the indoor/outdoor
antenna.
2. Check the connection of antenna.
3. Fine tune the channel.
4. Try another channel. Broadcasting failure may happen.
.
.
.
..
Other lnformation
lgnition
Black spots or horizontal streaks appear, <? r the pIcture
.
flutters or drifts. This is usually caused by mterference
from car ignition system, neon lamps, electric drills, or
other electrical appliance.
Ghost
Ghosts are caused by the television signal following two
paths. One is the direct path, � he other is r � flected � rom .
tall buildings, hills, or other obJects. Changmg the � irect1on
or position of the antenna may improve the recept1on.
Radio frequency interference
This interference produces moving ripples � r diago � al
streaks, and in some case, loss of contrast m the p1cture.
Find out and remove the radio interference source.
lf the TV is crashed
1. Press the Power button to turn off TV, then press the
Power button again to reset TV.
2. Unplug the power cord, then press the Power button
to reset TV.
Note: /f these 2 methods can not be reso/ved, please
contact the after-sa/es to solve.
Base lnstallation
To fix the double support base on the unit by screws,
the installation is completed.
Note: 11/ustrations be/ow are provided for reference only
and may differ from actual product appearance.
11
.
V.2
Publicidad
