Publicidad
Idiomas disponibles
Idiomas disponibles
English
CD Playback Operation
1. Press the Power Button to turn on the power.
2. Set the Function Switch to the CD position.
3. Press the Open/Close button to open the CD tray and put the CD in the tray
with the labeled side facing up.
4. Press the Open/Close button again to close the tray. The LED display will
show "--" for a few seconds, then the total number of tracks on the CD. If it is
a blank CD or an unrecognizable CD, it will show "00".
Note: MP3 or similar types of digital audio files cannot be read by the CD player.
5. Press the Play/Pause button to start the playback. The Play Indicator will light
up.
6. During the playback, press the Play/Pause button to pause and the Play
Indicator will starting flashing. Press it again to resume playback.
7. To skip to the next or previous track, press the Forward Skip or Backward
Skip button correspondingly.
8. To search fast forward or backward, press and hold the Forward Skip or
Backward Skip button correspondingly until you reach the desired time.
Release the button and the playback will resume.
9. To repeat a specific track, press Repeat button once while that track is
playing and the Repeat Indicator will start flashing. To repeat all the tracks,
press the Repeat button twice and the Repeat Indicator will remain on. To
cancel repeat function, press the Repeat button until the Repeat Indicator is
off.
10. Press the Stop button if you want to completely stop playback.
Programmed Playback
1. Before starting the playback, press the Program button once to enter
program mode. The Program Indicator will start flashing. The LED display
will flash "01" as the track sequence which is to be edited.
2. Press the Forward Skip or Backward Skip buttons to select the desired
track that you would like to play. The LED's number will turn steady
instead of flashing, showing the sound track number at selection.
3. Press the Program button to confirm the selected track. The LED's
number will start flashing again showing the next track sequence which is
to be edited.
4. Repeat steps 2 & 3 for additional sound tracks that you would like to play.
The tracks can be in any number and repeated. A maximum of 20 tracks
can be programmed at one time.
5. Press the Play/Pause button to start the programmed playback. The
tracks will play in the same sequence that you programmed earlier.
6. To exit the program mode, press the Stop button twice and the Program
Indicator will be off.
9
Publicidad
