HQ-Power PSS6EMV30 Manual Del Usuario página 4

4. Operation
1. Set the voltage selector switch in accordance with the voltage requirement of your
electronic device.
2. Verify the mA requirement of the unit and determine if it can be used with this adapter.
3. Determine the polarity of the unit. The polarity of the device can be found on the device or
in its manual.
4. Select a proper adapter plug and plug it into the DC input jack of the device.
5. Plug the adapter into the mains. If the unit does not operate properly, check the polarity
setting immediately.
6. Disconnect after use.
5. Technical Specifications
supply voltage ................................................................ 100-240 V~, 50/60 Hz, 0.8 A max.
max. output ............................................................................................................. 30 W
4 selectable output voltages ............................................................. 13.5 - 18 - 24 - 30 VDC
cable length ............................................................................................................ 1.8 m
dimensions ............................................................................................. 98 x 54 x 33 mm
weight .................................................................................................................... 175 g
Use this device with original accessories only. Velleman nv cannot be held
responsible in the event of damage or injury resulting from (incorrect) use of this
device. For more info concerning this product and the latest version of this manual,
please visit our website www.hqpower.eu. The information in this manual is subject
to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual may be copied, reproduced, translated or reduced to any electronic
medium or otherwise without the prior written consent of the copyright holder.
V. 02 – 29/11/2019
PSS6EMV30
4 ©Velleman nv