Baby Trend TS11S Serie Manual De Instrucciones página 9

Ensure the stroller adapters are
positioned on the middle position. See
step 10 for installation.
Attach the seat by lining up the seat
anchors on the side of the seat with
the anchors on the stroller frame and
pushing them together until they
click securely (Fig. 11e). The seat can
face in either direction, frontward or
backward.
Carriage Mode
Make sure the buckle strap
underneath the seat is unbuckled.
Then loosen the recline seat strap by
squeezing the adjuster and pulling
downwards (Fig. 11f). The carriage
should be fully extended before using.
NOTE: The footrest area should be
unbuckled (Fig. 11g).
13
Copyright © 2023, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Fig. 11e
Recline Seat Strap
Buckle Strap
Fig. 11f
Fig. 11g
BUMPER BAR HANDLE COVER
12
To attach: Before attaching the bumper bar to the stroller,
wrap the handle cover around the bar (Fig. 12a).
BUMPER BAR
13
WARNING:
or carry seat with child inside. The bumper bar is not a
carrying handle.
WARNING-FALL HAZARD:
bar is not designed to support a car seat, stroller may
become unstable.
Attach the bumper bar by lining up anchors with the slots on the seat.
Push until it locks into place (Fig. 13a).
securely attached before using this product.
To detach the bumper bar, press the release button on the bottom of
the bar on each side, and pull bar out of the anchors (Fig. 13b).
Fig. 13a
Copyright © 2023, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Fig. 12a
Do not use bumper bar to lift
Bumper
NOTE: The bumper bar must be
Fig. 13b
14