HQ-Power VDPDMXDP152 Manual De Instrucciones

VDPDMXDP152 – 4-CHANNEL DMX DIMMER PACK
1. Introduction & Features
Thank you for buying the VDPDMXDP152 ! Please read the manual carefully before bringing
this device into service.
This device is 4-channel dimming power pack with LED indication, controlled by analogue input
or DMX input, while also providing a power supply for an analogue controller.
Check carefully for damage caused by transportation. Consult your dealer and don't install this
device if it has been damaged in transit.
2. Safety Instructions
Be very careful during the installation : touching live
wires can cause life-threatening electroshocks.
Keep this device away from rain and moisture
Unplug the mains lead before opening the housing
• A qualified technician should install and service this device.
• Damage caused by disregarding certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for the ensuing defects or problems.
• Do not switch the device on immediately if it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room
temperature.
• This device falls under protection class I. It is essential, therefore, that the device be earthed.
Have this device installed by a qualified technician.
• Make sure that the available voltage does not exceed the voltage stated in the specifications
of this manual.
• Do not crimp the power cord and protect it against damage from sharp edges. Ask an
authorised dealer to replace the cord if necessary.
• Always disconnect the device from the mains when it is not in use or when you wish to clean
it. Only handle the power cord by the plug. Never pull out the plug by tugging the power cord.
• Note that damage caused by user modifications to the device is not covered by the warranty.
Keep the device away from children and unauthorised users.
3. General Guidelines
• This device is a lighting controller for professional use on stage, in discos, theatres, etc. The
VDPDMXDP152 should only be used indoors with the included adapter working on an
alternating current of max. 230Vac/50Hz.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device will be protected against extreme heat, moisture and dust.
• Do not use or transport the device under temperatures < 5°C or > 35°C.
VDPDMXDP152 1 VELLEMAN