Publicidad
Idiomas disponibles
Idiomas disponibles
> Before Start
> Part Names
■ 2. Level Calibration
Front Left
Select a value between "j12 dB" and "i12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
Center
Select a value between "j12 dB" and "i12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
Front Right
Select a value between "j12 dB" and "i12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
Height Left
Select a value between "j12 dB" and "i12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
Height Right
Select a value between "j12 dB" and "i12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
Subwoofer
Select a value between "j15 dB" and "i12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
44
> Install
> Initial Setup
> Playback
■ 3. Dolby Enabled Speaker
Dolby Enabled
Set the distance between the sound bar and the ceiling. Select
Speaker to Ceiling
between "0.1ft/0.03m" to "15.0ft/4.50m" (0.1ft/0.03m units).
(Default Value is "1.80m")
0 Distance units (feet/meters) can be switched by pressing
MODE on the remote controller.
AccuReflex
You can enhance the reflection effect from the ceiling.
"On (Default Value)": Use this function
"Off": Do not use this function
Advanced Setup
| Firmware Update | Others
E
N
Publicidad
