Fellowes Powershred M-3C Manual De Instrucciones página 3

BASIC SHREDDING OPERATION
PAPER/CARD
1
Continuous operation:
Up to 3-minute maximum
Set to Auto-On (
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
3-minutes will trigger
30-minute cool down period.
Safety Lock prevents accidental operation.
To unlock, slide black button up. For greater safety, always unplug shredder after use.
PRODUCT MAINTENANCE
OILING SHREDDER
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
TROUBLESHOOTING
PAPER JAM
1 2
Set to Reverse ( ) Alternate slowly back and forth
for 2-3 seconds
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 1 year from the date of
purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free
from defects in material and workmanship for 3 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. This
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or
unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs
Australia Residents Only:
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other
The benefits under Fellowes' Warranty are in addition to other rights and remedies under a law in relation to the shredder.
2 3
Feed paper/card When finished shredding,
)
straight into paper set to Off ( )
entry and release
To set, wait for shredding to stop, set control switch to Off (O) position, then slide black button down.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
Set to Off ( ) *Apply oil across entry
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
3 4
Set to Off ( )
and unplug
3
Set to Reverse ( )
for 2-3 seconds
5 6
Set to Auto-On (
Gently pull uncut
paper from paper and resume shredding
entry. Plug in
incurred by Fellowes to provide parts or services outside of the country where the shredder is initially
sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE
or incidental damages attributable to this product. This warranty gives you specific legal rights.
The duration, terms, and conditions of this warranty are valid worldwide, except where different
service under this warranty, please contact us or your dealer.
Shredder doesn't start:
Make sure switch is in auto position (
Make sure safety lock is in unlock position.
Make sure head is on basket correctly.
Check for jam.
)
Remove and empty basket.
Wait 30 minutes for motor to cool down.
).
3