Publicidad
Idiomas disponibles
Idiomas disponibles
24. SINGLE-BUTTON
For choosing single playback or Continuous play. The indication "SINGLE" means that the CD-player is in
Single-mode. The current track is then played once and the player goes into Pause-mode at the beginning of
the next track. By pressing the Single-button, the CD-player changes into normal playback mode and the
display shows "CONTINUE".
Press and hold the Single-button for activating the Outro-function. The display shows "Remain Outro". In this
mode, the last 30 seconds of every track are played. Cancel the Outro-function by pressing the Time-button.
25. BPM/TAP-BUTTON
Via the BPM/TAP-button, you can switch the display from beats per minute (BPM) to speed-adjustment in %.
Via the BPM/TAP-button, you can display the beats per minute of a track. Press the button in the rhythm of
the music. The display shows the current beats per minute (BPM).
Rear panel:
®
www.omnitronic.com
CONNECT TO
CONNECT TO
MAIN UNIT
MAIN UNIT
2
1
26
26
26. CONNECTOR PORTS
Connect the main unit here.
5. INSTALLATION
Install the CD-player on a plane surface or in your rack.
Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
Remove the protection foil from the display.
Please note that the LCD-display can only be read from an angle of 45° to the top and of 5° to the bottom.
Rack-installation: This CD-player is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the CD-player into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the CD-player with four screws M6 in the rack.
Be aware that fastening the device with four screws on the front panel is not enough. In order to ensure
safety, additional fastening by using ground and side bars is necessary.
CAUTION: Make sure that the CD-player is switched off (power-switch in outer position) before you connect
it to the mains in order to avoid damages on your loudspeakers.
Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
Make sure that the indication on the Voltage-selector corresponds to the available voltage in order to avoid
severe damages. Only plug the power-plug into safety-sockets.
Connect your CD-player with the mains.
25/55
10602320_V_1_0.DOC
Publicidad
