Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
10
Connecting the stake
□
Attach the stake (E) to the bottom of the tube assembly (B).
11
□
CAUTION:
DO NOT use a hammer.
into the ground. For ground with hard soil, use a
trowel (not included) to loosen soil.
12
Connecting the wires
□
Detach and place the wire connector (D) on opposite sides of the low voltage cable (G) from the power pack (F) where the xture
will be located.
Align and t the main low voltage cable vertically to the slot of the wire connector (D).
□
Press the wire connector (D) together until it is locked around the main low voltage cable. Pre-set prongs will pierce the cable
□
insulation and establish contact with the electrical wire inside.
□
Once the wire connector is in place, wrap it with electrical tape
D
13
C
G
10ft
3m
(not included)
for additional protection.
7
Please contact 1-855-235-8715 for further assistance.
B
E
HOMEDEPOT.COM
Publicidad
