Publicidad
General
After the installation of the electric kit, the obligatory
trailer lighting as well as the trailer indicator control
which is statutory in a several countries are guaran -
teed without having to make any connections on the
vehicle!
The message "Control unit incorrectly coded"
however, appear in the fault memory ( 19 – Diagno -
sis interface for data bus)! Yet this entry has no
effect on the other functions and can be ignored
until your next regular service appointment. We
recommend the connection via the factory-mounted
service tester (VAS 5051 / 5052) within the
framework of the annual service intervals!
Please effect coding as follows:
• Vehicle self-diagnosis
• Gateway assembly list
• 19 – diagnosis interface for data bus
• 007 - coding (Service 1A)
• 69 – trailer function ( switch to
coded!)
Vehicles with park assist system
After the effected connection, the rear park
assist system will also automatically be deacti -
vated in trailer operation!
OPTIONAL - depending on model:
C2 control lamp for trailer indicator system
The C2 control lamp
flashes when the indicator is switched on if a trailer
has been connected to the vehicle. Without
activation the control lamp also continues to flash if
a trailer indicator fails; the error is shown by the bulb
failure display
After successful activation:
if an indicator fails on the trailer the
control lamp
44
/
87210622/16.01.2018
PF Jones Ltd, Nuttall street, Old Trafford, Manchester, M16 9JA, Tel- 0161 872 4755 email- info@pfjones.co.uk web- www.pfjones.co.uk
Set up trailer operation
2009
will,
in the combi-instrument
in the combi-instrument!
does not flash!
2009
Please effect coding as follows:
• Vehicle self-diagnosis
• Gateway assembly list
• 19 – diagnosis interface for data bus
• 007-Coding (service $1A) \ Read / write long coding
• 69 – trailer function ( switch to coded!)
Vehicles with park assist systems
The automatic deactivation of the rear park
assist system in trailer operation will be effected
by means of the subsequent coding of the park
assist control unit:
• Vehicle self-diagnosis
• Gateway assembly list
• 10 - park assist system II / parallel park assist
• 008 Coding (service $22)
• Byte 0 - bit pattern xxxxxxx1
(x = accept the default values in the input field for
this purpose activate input mode (BIN) !)
• confirm with OK !
NOTE:
If the vehicle's rear fog lamp does not switch off
automatically in trailer mode the following code
must be entered in addition to the aforementioned
configuration of the central electrical system:
Vehicle self-diagnosis
• 09 Electronic central electrical system
• 007 Coding (service 1A)
• Vehicle's electrical system controller coding long
• Byte 8 - bit pattern x1xxxxxx
(x = accept the default values in the input field
for this purpose activate input mode (BIN) !)
• confirm with OK !
15/17
Publicidad
