Publicidad
ASSEMBLY MONTAJE
4)
• With the wheel in position, install the
axel nuts and tighten with standard
crescent, box, or open end wrench.
You should feel significant resistance
and the wheel should be held tightly
in place (Fig. 4).
• Cuando la rueda esté en la posición
correcta, ponga las tuercas en
el eje y atorníllelas con una llave
inglesa, llave abierta o de pipa.
Apriételas hasta que sienta bastante
resistencia. La rueda debe quedar
fija (Fig. 4).
FENDER
GUARDABARROS
To secure the fender to the frame, use the 4 screws provided.
Para sujetar el guardabarros al armazón, use los 4 tornillos provistos.
5)
• Examine the bottom of the front fender. You will notice four 1/4 inch
diameter plastic tubes protruding from the bottom (Fig. 5a).
• These tubes must be lined up with the
holes in the front frame assembly (Fig.
5b).
• Line up the front fender and press onto
the front frame assembly (Fig. 5c).
• Insert the 4 screws through the underside
of the front frame assembly into the front
fender's plastic tubes. Tighten the screws
only until snug (Fig. 5d).
DO NOT OVER TIGHTEN.
• Examine la parte inferior del guardabarros
delantero. Notará cuatro tubos plásticos
de ¼ pulgada de diámetro que
sobresalen de la parte inferior (Fig. 5a).
9
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
• Estos tubos deben estar alineados con los
agujeros del armazón delantero (Fig. 5b).
• Alinee el guardabarros delantero y
presiónelo en el armazón delantero (Fig.
5c).
• Introduzca los 4 tornillos por debajo del
armazón delantero en los tubos plásticos
del guardabarros delantero. Ajuste bien
los tornillos sin forzarlos (Fig. 5d).
NO AJUSTE DE MÁS.
Fig. 4
REAR WHEEL
RUEDA TRASERA
6)
• Lean the stroller forward to rest on the
front wheels. To attach the rear wheels,
push each wheel's axle into the plastic
corner fitting (Fig. 6). Depress the
metal lever on the inside of the corner
fitting as you push the axle into corner
fitting. When the wheel will not go on
any farther, release the lever.
Check that the wheel has locked
Note:
into the corner fitting by pulling on the
wheel. If not locked, lift upward on the
lever, push the wheel on farther and
release lever.
Fig. 5a
• Ensure that the wheels are firmly
locked into place.
stroller if the wheels are not locked into
place, contact our customer service
department immediately at 1-800- 328-
7363, between the hours of 8:00 a.m.
and 4:30 p.m. PST, for assistance.
.
Fig. 5b
8
11
ASSEMBLY MONTAJE
use the
NEVER
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Fig. 5c
Fig. 5d
Fig. 6
10
Publicidad
