Publicidad
Idiomas disponibles
Idiomas disponibles
Foreword
EN
Thank you very much for choosing the FitWood LUOTO stool. Please read this guide thoroughly
before assembly and follow each process step by step so you can enjoy the product safely.
Please keep this guide for future reference. Should you need assistance with assembly, contact us
directly.
FitWood Ltd.
Hautalankatu 20
33560 Tampere
Finland
info@fitwood.com
Disclaimer
Read all instructions before using the product and follow assembly instructions accordingly.
FitWood cannot be held responsible in any way for any loss or injury, howsoever caused, as a result
of neglecting the instructions, misusing the product or misunderstanding the information contained
in this document or on our website.
Warranty applies only for the defects in the product and in case of complaint only the product
or its component will be replaced. The warranty does not cover damage due to negligent use of
the product, natural wearing of the product material or features, or breakage that is caused by an
unfavorable environment. FitWood Ltd will not be liable for any injury or death resulting from
improper assembly, maintenance or use of this product. FitWood's warranty is limited only to
repairing or replacing a faulty product.
For the assembly you will need
• Power Drill or manual screwdriver with Torx TX25 Drill Bit.
Make sure you have the following parts
6
Assembly instruction
Always tighten the screws slowly. The material is wood and may crack as a result of excessive
force. After all the screws are in place, check that they are correctly tightened.
- Assemble the stool on a soft surface, such as cardboard or a carpet.
- Remove all packaging material before assembly.
- Sort through all parts ahead of time to ensure you have everything you need.
Step 1
Cover the floor to prevent scratching the floor or the stool during assembly. Place the seat on a soft
surface with the screw holes facing upwards.
Step 2
Screw all the rungs into the seat. Avoid using unnecessary force and fixing the rungs too tight.
EN
7
Publicidad
