Descargar Imprimir esta página

Craftsman Z7000 Manual Del Usuario página 26

Publicidad

Idiomas disponibles

Idiomas disponibles

MAINTENANCE
3. Move to the opposite side, check that
measurement is the same. If adjustment is
required—with a 3/4" or adjustable wrench,
turn the lift link adjustment nuts on either
side counter clockwise to lower or clockwise
to raise. Adjust until both measurements are
equal.
4. Turn either blade to align with the deck front-
to-rear. If the front blade tip does not measure
1/4" to 3/8" lower than the rear, remove the
foot plate access the front deck adjustment.
With an adjustable wrench, loosen the rear
jam nut on the front suspension linkage.
Make adjustment to level with the front lift link
nut. Clockwise raises the front of the mower,
counter clockwise will lower the front. Adjust
the nut until rear blade tip is 1/4" to 3/8"
higher than the front blade tip.
NOTE: This will position the mower deck in a
standard measurement position. Depending on
the type of grass being mowed or environmental
conditions, additional adjustments may be
required to get the desired cut.
26
Cleaning
Regular cleaning, especially under the mower
deck, will increase the machine's life-span. Clean
the machine directly after use (after it is cooled),
before the debris sticks.
Do not spray water on the top of the mower deck.
Use compressed air to clean the top side of the
mower deck. Do not use a high pressure washer
or steam cleaner. Avoid spraying engine and
electrical components with water.
Regularly clean the underside of the deck with
normal water pressure. Attach the quick connect
(from the accessory packet) to any garden hose.
After mowing, snap the hose to the cleanout port
and turn on water supply.
Restart the mower and engage the blades to use
the spinning action to wash away debris. Make
sure the hose is away from the mower blades.
Do not rinse hot surfaces with cold water. Let unit
cool before washing.
CAUTION! Wear eye protection when
cleaning or washing the mower.
Hardware
Check daily. Inspect the entire machine for loose
or missing hardware.

Publicidad

loading

Este manual también es adecuado para:

917.277730