Publicidad
Idiomas disponibles
Idiomas disponibles
TURN ON THE APPLIANCE AND SELECT PROGRAMME
Turn on the appliance
1
1. Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket.
Make sure that the water supply is turned on to full pressure.
4. Open the door, press the power button.
5. Choose a program, the response light will turn on. Then close the door, the
dishwasher will start its cycle.
Change programme
2
A wash cycle can only be changed if it has been running for a short time otherwise,
the detergent may have already been released and the dishwasher may have already
drained the wash water. If this is the case, the dishwasher needs to be reset and the
detergent dispenser must be refilled. To reset the dishwasher, follow the
instructions below:
1. Open the door a little to stop the dishwasher, after the spray arm stop working,
you can open the door completely.
2. Press the Program button for more than 3 seconds, the dishwasher will enter
standby mode.
3. You can change the program to the desired cycle setting.
Add dishes during the programme:
3
A forgotten dish can be added any time before the detergent dispenser opens. If
this is the case, follow the instructions below:
1. Open the door a little to stop the washing.
2. After the spray arms stop working, you can open the door completely.
3. Add the forgotten dishes.
4. Close the door he dishwasher will continued to run after 10 seconds.
WARNING!
Be careful when opening the door during the dishwashing programme as hot steam
can be released and cause scalding.
117
Publicidad
