Publicidad
Idiomas disponibles
Idiomas disponibles
Questions?
Problem
Use this
LIGHTS
problem
Light during a
solver
speedcook cycle
dims and cycles on
and off, even at full
power levels
Light visible around
the door and outer
case while
speedcooking
FAN
Fan continues to run The oven is cooling.
after cooking stops
Oven vent emits warm This is normal.
air while oven is on
Fan comes on
automatically when
using the microwave
COOKING
The oven makes
unusual sounds
while cooking
Smoke comes out
of the oven when
I open the door
Food is not fully
cooked or browned
at the end of a
cooking program
SENSOR ERROR
displayed along with placed in the oven does
an oven signal
Troubleshooting
Possible Causes
This is normal.
Power level has been
automatically reduced
because the oven is hot.
This is normal.
This is normal.
Clicks and fans blowing
are normal. The relay
board is turning the
components on and off.
Food is high in fat
content. Aerosol spray
used on the pans.
Programmed times
may not match the size
or amount of food you
are cooking.
Food amount or type
not match the program
that was set.
Steam was not sensed by
the oven because plastic
wrap was not vented, a lid
too tight was on the dish
or a liquid was covered.
Advantium Oven
What To Do/Explanation
• This is normal. The oven senses the
heat level and adjusts automatically.
• When the oven is on, light may
be visible around the door and
outer case.
• The fan will automatically shut off
when the internal parts of the oven
have cooled.
• These sounds are normal.
• Smoke is normal when cooking
high-fat foods.
• Increase or decrease time for
doneness or adjust the upper or
lower lamps for browning and
doneness.
• Press the CLEAR/OFF pad. Set the
oven program to match the food
or liquid to be cooked or heated.
• Vent plastic wrap, use a looser lid
or uncover liquids when cooking
or heating.
33
Publicidad
