MESTIC ME-80 Instrucciones De Uso página 10

ENGLISH
Making coffee
Open the water reservoir lid and fill the water tank with the desired amount of water.
You repeat the previous steps from step 3 to 5.
1. Turn the machine ON by connecting the plug into mains, both coffee buttons blink for three times .
2. Press any coffee button to start heating up.
3. When buttons stop blinking and shows steady light, The machine is ready for use.
4. Place a cup.
5. Open the operating lever, insert a capsule and then closed.
6. Press one of the two coffee buttons ( desired amount) while the light is blinking. The machine will start
making your cup of coffee
7. Open the operating lever after extraction stopped. The capsule will be automaticly ejected and drop into the
used capsule container.
• The pre-defined factory volume for Espresso coffee (20-25ml) / Lungo coffee (40-50ml)
• Extraction will stop automatically or press the selected coffee button to stop ahead
Energy saving mode
• Automatic Stand-by mode: the machine will turn into stand-by mode automatically after 5 minutes of non
use. The boiler turned off and the external surface of the machine cools down. All button indicator lights on
the control panel go out.
• When user press any coffee button again, the appliance leaves from standby mode, restart heating up
process until "Ready to use".
Warning
If both coffee buttons flash alternately (see illustration). Turn the device off, wait 2 minutes, and then turn it on
again to check if the problem is resolved. Otherwise, contact the authorized representative for examination, repair
or adjustment.