AEG KN 2 Instrucciones De Uso página 3

TECHNICAL DATA
Nominal power output .............................................................
Full load cutting rate ................................................................
Minimum cutting radius ...........................................................
Maximum cutting capacity
Steel plate (400 N/mm ) .......................................................
2
Steel plate (600 N/mm ) .......................................................
2
Steel plate (800 N/mm ) .......................................................
2
Aluminium (250 N/mm ) .......................................................
2
Weight without cable ...............................................................
Typically the hand-arm vibration is below 2.5 m/s
Typical A-weighted sound levels:
Sound pressure level ............................................................
The noise level when working can exceed 85 dB (A).
Wear ear protectors!
Measured values determined according to EN 50 144.
SAFETY INSTRUCTIONS
Please pay attention to the safety instructions in the
attached leaflet!
Appliances used at many different locations including open
air must be connected via a current surge preventing switch.
Always wear goggles when using the machine. It is
recommended to wear gloves, sturdy non slipping shoes
and apron.
Sawdust and splinters must not be removed while the
machine is running.
Never reach into the danger area of the plane when it is
running.
Always disconnect the plug from the socket before carrying
out any work on the machine.
Only plug-in when machine is switched off.
Keep mains lead clear from working range of the machine.
Always lead the cable away behind you.
SPECIFIED CONDITIONS OF USE
The nibbler is above all suitable for distortion-free cutting of
any shapes even with small radii from platelike work pieces
from steel, aluminium and plastic material
Do not use this product in any other way as stated for
normal use.
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is
in conformity with the following standards or standardized
documents. EN 50144, EN 55014-1, EN 55014-2,
EN 61000-3-2, EN 61000-3-3, in accordance with the
regulations 98/37/EC, 89/336/EEC
Manager Product Development
5 ENGLISH
.
2
Volker Siegle
.........................500 W
.......................1200 min
-1
.............................4 mm
..........................2,0 mm
..........................1,5 mm
..........................1,0 mm
..........................2,5 mm
..........................1,9 kg
...........................85 dB (A)
MAINS CONNECTION
Connect only to single-phase a.c. current and only to the
system voltage indicated on the rating plate. It is also
possible to connect to sockets without an earthing contact
as the design conforms to safety class II.
MAINTENANCE
The ventilation slots of the machine must be kept clear at all
times.
Use only AEG accessories and spare parts. Should
components need to be replaced which have not been
described, please contact one of our AEG service agents
(see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered.
Please state the Article No. as well as the machine type
printed on the label and order the drawing at your local
service agents or directly at: AEG Elektrowerkzeuge,
Max-Eyth-Straße 10, D-71364 Winnenden, Germany.
SYMBOLS
Always disconnect the plug from the socket
before carrying out any work on the
machine.