Greencut JET-4800SX Manual De Instrucciones página 76

76
CONNECTING HIGH-PRESSURE HOSES
ATTENTION: Use only the high pressure hoses and fittings supplied with the unit. Make sure all
hoses and fittings are properly installed and secure.
1. Assemble the high-pressure hoses, lance and fittings into the required configuration.
2. Attach a nozzle to the end of the lance extension.
3. Connect the free end of the high-pressure hose to the pump outlet connector. Some models may provide a
threaded collar or "quick-connect" fitting. Ensure that threaded types are firmly tightened.
CONNECTING THE WATER SUPPLY
The machine must be connected to a water supply that can deliver sufficient water for pumping. Most domestic
applications will use a standard garden hose connected to the mains water supply. In cases where no mains or gravity
fed water supply is available, the machine can draw water from a suitable reservoir using the supplied inlet hose and
strainer.
ATTENTION: When using a garden hose and mains water supply, it is recommended to run water
through the hose first to flush out any debris BEFORE connecting it to the pump inlet. Do NOT use
hot water or water at temperatures above 40°C (104°F) as damage to the pump may result. Using
hot water in the machine may void the product warranty.
MAINS WATER SUPPLY
1. Connect a standard garden hose to the water supply and the pump inlet connector. Ensure that the
connections are secure.
2. Turn ON the water supply.
3. Squeeze the trigger on the lance. When a steady stream of water is flowing from the nozzle, the machine
is ready to be used.