Publicidad
Idiomas disponibles
Idiomas disponibles
2. When you see the digits start blinking, press the Up Button (14) and Down Button
(15) discontinuously to adjust the target torque value.
3. If you want to quickly go through to the target torque value, just press it the Up
Button (14) and Down Button (15) continuously.
4. When the target torque value is displayed, press the Setting Button (16) 2 seconds to
confirm your selection. (or wait for 5 seconds the system will automatically
confirm your selection)
NOTE
1. When you are reaching 90% of the target torque value, an intermittent buzzer
will start to warn you.
2. When the target torque value is reached, a high-frequent buzzer will warn you
not to pull further.
MEMORY FUNCTION
The system will memory the "mode" and "unit" selection which you set even you
change coin cells.
RESET MEMORY FUNCTION
To clean the memory, just press the Down Button (15) and Up Button (14) together for
2 seconds.
COUNT FUNCTION
Just press the Power Button (13) and Up Button (14) together to show how much times
this wrench has been used.
NOTE
The system will record this time automatically when the torque value
reaches the target torque value you set. The counter unit is thousand as shown "K",
and the maximum is 999K.
OVERLOAD ALARM/RECORD
The system will show "Err" on the display if the torque exceeds 110% of the maximum
torque, and a high-frequent buzzer will warn you not to pull further. After that the
"Err" will be shown for 1 second every time when you power on this wrench.
NOTE
Overload will damage this wrench and lose its accuracy. Please return
1English1
English
-10
Publicidad
