Casselin CG180D Guía De Usuario página 14

WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the
device in malfunction, and do not use spare parts that are not original.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.
5.2 Use
WARNING
The set-up of the device installation and maintenance should only be carried out by professionals.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
START-UP
The device must be completely removed from its packaging and the protections must be completely removed.
Place the device on a solid, stable, flat and non-flammable surface.
Do not place the appliance against the wall.
Do not install the device near open fires or other heating devices.
It is forbidden to place flammable objects on and near the appliance.
Make sure that all ventilation openings are not blocked.
Make sure that the device is placed for optimal use.
The device must be electrically protected upstream with an adequate safety device.
The device should be plugged directly into a wall outlet, not a power strip.
Let the device heat up for 15 minutes before using it for the first time.
NEVER use cold water on the cast iron plates as you may cause thermal shock.
USE
Plug in the appliance, press the switch, the red light comes on.
Turn the temperature control knob. The temperature can be between 60 ° and 300 ° C.
We recommend that you use this device at a maximum temperature of 220 ° C.
Once the desired temperature has been reached, the red light goes out.
Pour the waffle batter in the center of the baking sheet. Close the appliance and cook for the recommended
cooking time using the timer.
When the temperature decreases, the appliance starts heating again and the red light comes on again.
At the end of use, turn the thermostat to 0 and press the switch in OFF mode.
TIMER
Count up: stopwatch
Count down: timer
'-' and '+': timer setting
Stopwatch
Start press '+' for the stopwatch. To stop, press '+'.
5 beeps to signal the stop of the stopwatch.
Timer
Pressing '-' and '+' simultaneously displays the default value: 10sec.
Tout le matériel CHR disponible sur notre site en cliquant ICI ou sur le logo et profitez des meilleurs offres et des meilleurs garanties
Tél: 09 71 04 20 23
Cliquez ici pour découvrir tout nos produits CHR
Cliquez ici pour le catalogue produits Casselin
Email: info@stock-direct-chr.com
EN