Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning
Keep the ventilation holes (6) and the motor housing
of the device clean. Use a damp cloth or brush to
do this. Do not use any cleaning agents or solvents.
This could damage the device irreparably.
Clean the saw blade holder with a brush or by
blowing out with compressed air. To do this,
remove the saw blade from the device.
Try to clean resinous surfaces with a damp,
lukewarm cloth that has been wrung out well. Make
sure that no liquids can get into the interior of the
housing!
Maintenance
Check the device before each use for obvious
defects such as loose, worn or damaged parts.
Check the covers and protective devices for
damage and correct fit.Replace these if necessary.
Replace a blunt or bent saw blade or one which has
been damaged in some other way.
10. CHARGER INDICATOR
Indicator Status
Red LED
Green LED
ON
OFF
Blink
OFF
ON
Blink
OFF
ON
Blink
Blink
Blink
OFF
GB
9. STORING AND TRANSPORT
Storage
Store the device in a dry and dustproof location and
Remove the rechargeable battery from the device
The optimum storage temperature for the battery
Charge the device at least once in 3-6 months to
Transport
Secure the appliance against slipping.
If shipping, use the original packaging wherever
Explanations and Actions
Ready for use
The charger is connected to the mains and is ready for use; there is no
battery pack in the charger
Pre-charge Mode (low-current safety charging)
As the battery pack voltage is under 12.5V,the charger is in Pre-charge
mode.the charging current is below 0.5A.This can maximum the life of the
battery.
High-current charging
As the battery pack voltage is above 12.5V,the charger is in quick charge
mode.the charging current is at 2.3-2.4A.
Important ! The actual charging times may vary slightly from the stated
charging times depending on the existing battery charge.
The battery is charged and ready for use.
The battery is fully charged and ready to use..
Action: Take the battery pack out of the charger. Disconnect the charger from
the mains supply.
Fault
Charging is no longer possible. The battery pack maybe defective.
Action:
Never charge a defective battery pack.Take the battery pack out of the charger.
Temperature fault
The battery pack is too hot (e.g. due to direct sunshine/prolonged use) or too
cold (below 40°F/4°C).
Action: Remove the battery pack and keep it at room temperature (approx.
68°F / 20°C)for3Hours.
12
out of reach of children.
before storing the device.
and device is between 32°F/0°C and 104°F/40°C.
Avoid extreme cold or heat during storage,so that
the battery does not lose performance.
preserve battery life span.
possible.
Publicidad
