CREATIME GONG TIMER Manual Del Usuario página 2

The GONG TIMER: Instructions for Use
1.
FITTING IN THE BATTERIES
Open the battery door and install 4 AA size alkaline batteries. All batteries should be brand new. Close the
battery door.
2. S
ETTING THE SESSION
1. Press the ON /OFF button
figures. Press the + and – buttons to select the number of minutes you wish your session to last (max. 199
minutes).
2. Press the MENU button. This icon
select the number of minutes you wish to set the intervals for (max. 60). E.g. If you select 12, a single chime
will sound every 12 minutes. If you prefer to have no interval chimes during your session, select 00.
3. Press the MENU button. This icon
the number (01 to 04) corresponding to the chime you wish to hear: 01 = dordje, 02 = bell, 03 = low-pitched
gong, 04 = medium-pitched gong. A sample of each chime can be heard with each selection.
4. Press the MENU button. This icon
select the number (01 to 10). A sample of the selected volume can be heard with the chime you have just
selected.
NOTE: You may change these selections by pressing the MENU button until you reach the icon symbolizing the menu
you wish to change.
S
3.
TARTING THE SESSION
You are now ready to start the session. Press the Play button /
This icon  is now displayed on the screen as well as the total duration of your session.
Ten seconds later, three chimes will signal the beginning of your session. The number of minutes displayed on
the screen will decrease every minute. When 00 is displayed, another three chimes will signal the end of your
session. Then the timer will stop automatically.
DURING THE SESSION
1) Pause: To pause during the session, just press the /
When you are ready to resume, press the /
continue where it was stopped.
N.B. After 20 minutes' pause the timer will stop automatically.
2) Volume: To change the volume, simply press the + button to turn the volume up or the – button to turn it down.
3) Stopping the timer: Press the ON/OFF button
NOTE: The latest settings will be automatically recorded. If you wish to use them during your next session just turn
on the Gong Timer, press the /
DISPLAY OF THE BATTERY ICON
If you use alkaline batteries, this symbol will start flashing to indicate that the batteries are getting low.
When the icon stops flashing the batteries need changing.
If you use rechargeable batteries, this icon will be displayed quite rapidly. This does not indicate the battery level so
just ignore it.
to start the timer. This icon
(intervals) appears with flashing figures. Press the + and – buttons to
(chimes) appears with flashing figures. Press the + and – buttons to select
(volume) appears with flashing figures. Press the + and – buttons to
button again. The  icon will stop flashing and the session will
until the screen goes blank.
button and the session will start.
2
(duration of the session) appears with flashing
button. The  icon will start flashing.