Beamz professional LED PARBAR 4Way Manual De Instrucciones página 5

Settings
MASTER FLATPAR
Below setting for the FlatPar with built-in IR-sensor only!
Press "MENU" until display show "IrOn" or "IrOF". Then press " " or " " button
to choose "IrOn". Confirm by pressing the "ENTER" button.
SLAVE FLATPAR
Below setting for the FlatPar without IR-sensor!
Press "MENU" until display show "dxxx". Press " " or " " until display show
"d001" and confirm by pressing the "ENTER" button.
REMOTE CONTROL
To switch off the lights:
Press OFF on the remote control [1].
Manual Color Control:
You can set R/G/B/W colours with the remote by pushing either the Red <R> button for red, the
Green <G> button for green, the Blue <B> button for blue and White <W> button for White[3].
Preset colour mode:
Press one of the twelve preset colours on the remote control. [4]
Program:
Press one of the four program buttons to choose between the different auto programs [5]. Speed can
be changed with up and down button [1].
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the foil from
the battery support on the rear side of the remote control. Otherwise operation of the remote control is not
possible.
If the range of the remote control decreases, replace the battery. For this
purpose, on the rear side of the remote control press the small bar with the
groove to the right (1) and at the same time remove the battery support (2). For
operation, one 3 V button cell type CR 2025 is required. When inserting, pay
attention that the positive pole of the button cell shows upwards in the support.
5