RECOMMENDED TOOLS AND MATERIALS
Putty Knife - Flat screwdriver - Adjustable wrench – Sealant -
Tape measure – Hacksaw - Carpenter's level.
(*) Not included
INSTALLATION INSTRUCTIONS
INSTALLATION DIMENSIONS
ADA for adults: 865mm (34")
Standard: 815mm (32")
ADA for kids: 785mm (31")
Finished
Floor
4
Carefully position the lavatory on wall
hanger and mark points to anchor holes.
5
Take out the lavatory
and drill at the marked
points then install nylon
Clean or wash with soapy water. Wash off the soap with clean water and dry with a soft cloth. Never use abrasive products
or materials which could damage the surface. Doing so will void warranty. Do not use cement or rigid plasters.
INSTALLATION INSTRUCTIONS
1
Check
water and
drain points
210
height as
(8 1/4")
shown.
Water
supply
*
*
550
500
(21 5/8")
(19 3/4")
(*) Dimensions shown for location of water supply
and drain are recommended.
6
Install the faucet (not included)
according to the manufacturer's
7
Mount the lavatory on wall hanger, install and
tighten the mounting bolts.
Plastic
washer
Nylon plug
ANCON 2.0 LAVATORY
CAUTION
This product is heavy and fragile,
To avoid breakage and possible injury,
it should be handle with care.
Do not use putty or cement.
2
Draw on wall a drain vertical center line.
Then mark an horizontal line to "A" distance
from finished floor to define location of
anchor holes for wall hanger as shown.
10
(3/8")
Drain
A
*
200
(7 7/8")
A
ADA for adults
855mm (33 5/8")
Standar
805mm (31 3/4")
ADA for Kids
775mm (30 1/2")
Bolt
Metalic
washer
Nylon plugs
Screws
3
Install wall hanger considering points
marked on wall..
9
grout around lavatory.
8
Install the trap
and drain ( Not
included), according
to the
manufacturer's
instructions.
In case of installing the lavatory for the
disabled use, according to ADA, install
the appropriate supports (not included).
Customer Service
TREBOL-CELIMA
Telf
. : (511) 614-0303
acliente@celima.com.pe
www.celima-trebol.com
Wall Hanger
Apply sealant or