Publicidad
Idiomas disponibles
Idiomas disponibles
Detailed Description of Functions
1. Heating Function:
In the power-on state, the water heater directly heats. When the water heater
reaches the set temperature, it stops heating and enters the insulation state.
Then, if the water temperature drops below the set temperature by 8 degrees,
reheat and cycle. In the heating state, it is lit according to the actual
temperature, the temperature indicator is on, and the current set temperature
indicator flashes.
2. Insulation Function:
When entering the insulation state, the temperature indicator lights up the
corresponding indicator according to the actual temperature.
3. Automatic Sleep Function:
(1) In the power-on state, if there is no key operation for 3 minutes, it will enter
the screen saver state (except heating and anti freezing), and the brightness
of the indicator light will dim.
(2) In the heating state, reservation state and anti freezing state, it does not
enter the screen saver.
(3) In the screensaver state, press any key to wake up (if you enter the
antifreeze function automatic wake-up), you will return to the display content
in front of the screensaver, and you can press the key at this time.
4. Memory Function:
It has memory function (memorizing the on-off state and setting temperature).
After power failure, it can automatically return to the working state before
power failure.
5. Memory Clearing Function
Press and hold the " " and "
indicator light will be fully on, and the buzzer will beep. After 2 seconds, it will
enter the standby mode. At this time, press the " " key to return to the
factory default value (standby mode, set temperature 70°C).
6. Antifreeze Protection Function
When the system detects that the water temperature of the inner tank is ≤ 6°C
under power on, it will heat automatically. When the temperature of the inner
tank is ≥ 10°C, it will stop heating. (when heating, the indicator light is not
displayed, i.e. hidden heating mode).
7. Buzzer Function:
The sound is sent out by the buzzer. In case of failure, it shall sound 10 times,
and each effective key operation shall sound 1 time.
8. Safety Self-Inspection Function:
Whether in the state of power-on or shutdown, the water heater carries
out real-time and all-round safety self inspection (dry burning, sensor and
overtemperature fault detection).
" keys for 3 seconds at the same time, the
9
Publicidad
