Publicidad
Idiomas disponibles
Idiomas disponibles
6. Fill tank with water then add the desired cleaning solution.
It is recommended to put the water first, to avoid foaming. Place tank on shampooer.
DO NOT USE SOAP OR DETERGENT ON CARPET.
7. Lower handle to the operating position, and turn the unit on. When brushes start
rotating, press the dispenser trigger to release shampoo solution.
DO NOT SOAK TO AVOID MILDEWING AND DISCOLORATION.
8. Clean small areas of 3 x 3 feet at a time using slow foward, sideways and
backwards strokes until a small uniform film of foam disappears. (Fig. B)
9. Proceed to another area in the same manner. Make sure that the last
movement in one area is in the same direction as the last area.
10. Allow carpeting to dry completely, preferably overnight. Ventilating the room or
using a fan may reduce drying time. If your need to walk over a wet carpet, protect it
with a white cloth or towel.
11. Once dry, vacuum the carpet to remove all crystalized debris.
KEEP FLOORS CLEAN Vacuum Hardwood floors daily.
BUFFING
CLEANING
POLISHING
DEEP CLEANING
PROBLEM
All manuals and user guides at all-guides.com
HARDWOOD FLOOR CARE
Buff once or twice a week to remove scuff marks and improve the shine of the hardwood floor.
Make sure that the floor is dry. Attach the lambswool or felt pads over the polishing or scrubbing
brushes. Secure with the pad retainers. To remove stubborn scuff marks use the tan cleaning
pads. Turn the unit on and glide the machine over the surface with forward and backward strokes,
following
the
direction
Hardwood floors may be damp mopped with a ph balanced neutral cleaner if they have been
previously sealed with a polyurethane finish. Always avoid excess water on wood floors.
To polish using paste wax, apply the wax by hand and let dry. Use the machine with polishing
brushes or dry tan pads placed over the polishing brushes. Turn the unit on. Glide the
machine over the floor with forward and backward strokes following the direction
of the grain. If you apply two or more layers of wax, polish the first layer before
applying the second layer. Never pour liquid wax into the tank. If a liquid wax finish is applied
to the wood floor by hand, let it dry, they buff with the lambswool pads if desired.
A sealed hardwood floor may be deep cleaned if excessively soiled. Dilute a neutral cleaner in the
tank following the instructions on the product. Use the machine with the tan pads placed over the
polishing or scrubbing brushes. Pull the trigger to dispense the cleaning solution
of the floor. Do not place too much water on the floor and dry immediatly after cleaning.
IF YOU HAVE A PROBLEM
POSSIBLE CAUSE
of
the
grain
until
SOLUTION
-8-
FIG. B
the
desired
finish
is
achieved.
Publicidad
