Publicidad
Idiomas disponibles
Idiomas disponibles
21
Home
Technical background
The philosophy behind NeuLog's plug and play
technology is based on each sensor's ability to store its
own data due to an internal flash memory chip and
micro-controller in each plastic NeuLog body. This
technology allows the sensor to collect and then store
the digital data in the correct scientific units (for
o
o
example:
C,
F, Lux, %, ppm).
The sensor is pre-calibrated at the factory. The built-in
software in the logger can be upgraded for free at any
time using the provided firmware update.
Inside the anemometer sensor a magnet is situated
within a metal coil. The magnet is connected directly to
the wind speed detector which causes it to spin with the
same velocity as the wind propelling it.
The shaft is installed in a bearing and has a magnet at
its end. A digital sensor based on the Hall Effect sensor,
an analog circuit and a very sophisticated digital
processor are located near the rotating magnet.
The analog and digital circuits analyze the rotating
magnetic field, calculate the rotation speed and transfer
this data to the controller upon its request. The controller
converts this data into air flow velocity.
V2018.01
English
Publicidad
