Descargar Imprimir esta página

Mag-Torch MT16 Instruction Manual página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Use only Butane fuel when refilling torch.
2. Ensure that the torch is extinguished before refilling.
3. Allow sufficient time for torch to cool to room temperature before refilling the torch with fuel.
4. Refill torch in a well ventilated area free of fire or other sources of ignition and away from people.
5. Never smoke while refilling the torch.
6. Hold the torch with the FILL VALVE (C) up.
7. Invert fuel canister and insert the fuel canister tip into the FILL VALVE (C).
8. Push the fuel canister and torch together to allow fuel to flow into the torch fuel tank. Torch should be filled in about 10
seconds.
9. Stop refilling once the fuel begins to overflow.
10. Wait 3 minutes to allow fuel gas to stabilize before igniting the torch.
Exercise caution when using this device not to breathe vapors. Depending on the task being conducted with device (wood burning, melting
plastic, etc.) toxic or nauseating vapors may exist.
INTERMITTENT USE MODE
1.
At the same time, press tip of thumb against Cover Lock "A" while pushing down on Ignition Button "B". You must do both actions at the
same time or torch will not ignite.
2.
If no flame appears, adjust the regulator on the filling valve by hand turning the filling valve to the clockwise or counter clockwise
direction for a proper flame length. (See C)
ADJUST FLAME
1.
Slide FLAME ADJUSTER (C)
USE AS A GAS TORCH
(This is an open flame. Do not use with combustibles in the area. Read warning sections of instruction)
1.
Torch is factory set for use as a gas torch and can be used immediately; after refilling.
2.
Ignite torch as shown above.
1.
Before each use and after refilling, listen for leaking. Never use a flame to check for leaks. Always use torch in a well-ventilated and
spark-free area and where there are no open flames.
2.
In cold weather size of flame will be smaller. To produce larger flame, pre-warm torch to room temperature prior to use.
1.
After use, push the Flame Nozzle Cover to lock and make sure that the "hands free" flame lock is in the off position.
2.
Allow several minutes for torch to cool. Never leave torch unattended.
3.
When torch is cool, store torch out of reach of children.
4.
Do not expose torch to temperatures in excess of 120°F/49°C
5.
Store torch in well ventilated areas.
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET CES INSTRUCTIONS
NO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES | NÃO DESCARTE ESTES AVISOS DE ATENÇÃO E INSTRUÇÕES
LIGHTING AND OPERATION
200 Old Wilson Bridge Road
Columbus, OH 43085
REFILLING OPERATION
ADDITIONAL WARNINGS
STORAGE
423711 02/20
MagTorch.com

Publicidad

loading