Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTION
ATTACHING WORK LIGHT HEADS
TO STAND (FIG 2)
1. Place the stand (7) on a flat surface.
2. Rotate the carrying handle (1) straight up. Tighten the
handle locking knob (G3) to secure it in place.
3. Install one work light head (2) on the stand (7) by
sliding and positioning the U-shape bracket (9)
under the bolt cap (G2) as shown in FIG 2. Tighten
the locking knob (G1) to secure the work light head in
place. Repeat the procedure on the second work light
head.
4. Hang the power cable splitter (H) on the hook (G4).
ADJUSTING THE TRIPOD (FIG 3)
1. Loosen the tripod locking knob (F).
2. Push down the leg connector (A) until the legs (B) are
fully extended and firmly tighten the locking knob (F).
3. Adjust the height of the tripod by unlocking the flip
locks (C1 & C2) and raising the center poles (D1 & D2)
of tripod. Lock the flip locks when the tripod reaches
desired height.
NOTE
: The maximum height of this tripod is 60".
ATTACHING THE WORK LIGHT
ASSEMBLY TO THE TRIPOD (FIG 4)
1. Place the work light assembly on top of the tripod.
2. Use the bracket locking system (E1, E2 and E3) to
secure the work light assembly to the tripod as shown
in FIG 4.
NOTE
: Make sure the two locking brackets (E1) are
over the raised metal plate in the middle of the stand.
English
2
9
FIG 2
E1
E3
D2
D1
A
B
FIG 3
E1
E2
FIG 4
4
2
1
G4
G2 G1
G3
H
7
E
E2
C2
C1
F
B
E3
9
Publicidad
