Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS (continued)
5.
Insert the flange and upper portion of the pop-up drain assembly
(5.1) into the sink hole (5.2).
6.
From underneath the sink, attach the rubber gasket (6.1)
and mounting nut (6.2) onto the upper portion of the pop-up
drain assembly (6.3). Then twist the bottom of the pop-up
drain assembly (B) onto the upper portion of the pop-up drain
assembly (6.3) and hand tighten. Do not overtighten.
7.
After installation is complete, remove the aerator (7.1) from the
spout (7.2) on the faucet body (A) using the aerator key (BB).
Turn on the water supply. Check for leaks at all waterway
connections. If leaks occur, tighten the nuts on the water
connection that is leaking. Fill the sink with water to check the
drain for leaks. If water is leaking from the drain, tighten the
mounting nut on the pop-up drain assembly (B).
After the pop-up drain has been checked for leaks, empty the
sink. Run hot and cold water uninterrupted for at least one
minute to flush away any debris that could cause damage to the
internal parts.
8.
Turn off the water and reattach the aerator (8.1) onto the spout
(8.2) of the faucet body (A) using the aerator key (BB).
5
5
5.2
6
6.3
6.1
6.2
7
7.2
7.1
BB
8
8.2
8.1
BB
5.1
B
A
A
Publicidad
