Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT SPECIFICATIONS
SPECIFICATIONS
Max. flow rate: 1.8 GPM (6.814 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF 61-9
Chrome finish
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply
valve under the sink or at the
main water supply, disconnect
the supply line, and remove old
faucet.
Clean and dry surface area where
new faucet will be mounted.
2. Insert spout into body, making
sure the O-rings snap into place.
Hand tighten spout nut over
body threads.
Note: O-rings and washers are
already installed on the spout.
3. Screw flanges onto fine thread
side of swivel unions, flat side
facing away from faucet. Use a
wrench (not included) to tighten
swivel unions onto 1/2 in. stub out
pipes extending from wall. Insert
rubber washer into union nuts,
then fasten to body using union
nuts attached to the body.
Note: Do not overtighten.
4. Re-connect supply lines. Turn
water supply or shut-off valve
back on and check for leaks. If
leaks occur, gently tighten union
nut and swivel union until leaks
stop.
www.homewerksww.com
1
2
3
4
SPECIFICATIONS
Ceramic cartridges
Manufactured to include no more than 0.25% weighted average lead
content on wetted surfaces
Total weight of item: 3.156 lbs.
5. Remove aerator from spout.
Turn on faucet and run at least
30 seconds to flush out water
in line. Turn off faucet and
replace aerator.
6. To use the two-function aerator
turn while water is running.
This will create a stream or
spray pattern.
7. To create a moderate water
temperature, turn both handles
open. Slight adjustments of
either handle will cause the
water temperature to increase
or decrease.
2
5
6
Stream
Spray
Pattern
Pattern
7
Publicidad
