Sonia Keid Warm HZ-3361A-5H Manual Del Usuario página 3

SKETCH AND DIMENSIONS
OPERATION
● Connect the bed to an electrical outlet using the power
cord.
● To start up, the ON / OFF switch is found on the rear
under the backrest. Press it down to the "I" (ON) position.
● This panel also features the fuse and three electrical
sockets for the connection of accessories or work tools.
● Hand controller
1 2
3
4
5 6
7 8
- Press the button to activate the control knob. The
red indicator will light up and all its functions can be
used.
- Press the button again and the red indicator will
turn off at the same time as the bed remains flat and in
the lowest position possible.
- Press the buttons P1, P2, P3 to place the bed in one of
the 3 factory-stored positions.
- Press the button and the heating will start at normal
7
level. The indicator will light up green. Press the button
again and the heating will stop. The green indicator
7
will turn off.
- Press the button and the heating will start at high
8
level. The indicator will light up red. Press the button
again and the heating will stop. The red indicator will
turn off.
- Set any of the 3 factory-stored positions to a new
position:
• Once the bed is in the desired position, press the SET
button until the blue indicator lights up.
• While the blue indicator is lit, press one of the three
buttons (P1, P2, P3) for where you want to memorise
the new position.
• The new position will be memorised in the selected
button.
● Adjusting height
- Use the buttons
and
1
the height of the bed.
● Adjusting backrest tilt
- Use the buttons
3 and
the tilt of the backrest.
on the control knob to adjust
2
4 on the control knob to adjust
8
EN
3