Greencut BAS190C Manual De Instrucciones página 39

The operation of the float switch should be checked every 3 months. To check, place the pump in a container filled
with water and lift the float switch out of the water - the pump should stop, then put it back in the water - the pump
should start.
CONNECT THE HOSES
ATTENTION: • Always use the hose with the correct diameter. • Fit all hoses. The joints and clamps
have a suitable construction to handle the suction inlet and the pressure outlet. • Hoses should not
be damaged, twisted or scratched. • All connectors and hose connections should be secured and
properly sealed to ensure correct and reliable operation of the pump. • The pump should be used
in accordance with the specifications.
For best performance, always use the accessories of the outlet that are intended for the general application of the
water pump; for example, high pressure, water transfers, etc. The insufficiently compatible sizes of the hose can
influence the efficiency of the pump either by increasing the resistance of the pump (diameter of the hose is too small)
or by reducing the outlet pressure (diameter of the hose too large).
WATER PUMPING OPERATION
Note that as soon as the pump motor is running (power is switched on and in the "ON" position), the pumping action
of the machine is activated. Please take the following recommendations into account:
• Do not intentionally make debris enter the pump.
• Do not allow the pump to operate "dry"; that is, not having enough or adequate fluid to extract.
• After use, clean the pump and hoses to remove corrosive substances, debris or other impurities carried by the
pumped fluid.
39
EN